interface vfc1
bind interface Ethernet1/19
interface vfc2
bind interface Ethernet1/2
interface vfc90
bind interface Ethernet1/9
interface vfc100
bind interface Ethernet1/10
interface vfc110
bind interface port-channel110
interface vfc111
bind interface Ethernet1/11
interface vfc120
bind interface port-channel120
interface vfc130
bind interface port-channel130
interface vfc177
bind interface Ethernet1/7
fcoe fka-adv-period 16
This example shows the FCoE VLAN to VSAN mappings:
switch# show vlan fcoe
Original VLAN ID Translated VSAN ID Association State
---------------- ------------------ -----------------
400 400 Operational
20 20 Operational
100 100 Operational
500 500 Operational
200 200 Operational
300 300 Operational
This example shows the information about the vFC 130 interface including attributes and status:
switch# show interface vfc 130
vfc130 is trunking (Not all VSANs UP on the trunk)
Bound interface is port-channel130
Hardware is Virtual Fibre Channel
Port WWN is 20:81:00:05:9b:74:bd:bf
Admin port mode is NP, trunk mode is on
snmp link state traps are enabled
Port mode is TNP
Port vsan is 1
Trunk vsans (admin allowed and active) (1,20,100,200,300,400,500)
Trunk vsans (up) (500)
Trunk vsans (isolated) ()
Trunk vsans (initializing) (1,20,100,200,300,400)
1 minute input rate 0 bits/sec, 0 bytes/sec, 0 frames/sec
1 minute output rate 0 bits/sec, 0 bytes/sec, 0 frames/sec
15 frames input, 2276 bytes
0 discards, 0 errors
7 frames output, 1004 bytes
0 discards, 0 errors
last clearing of "show interface" counters Tue May 31 20:56:41 2011
Interface last changed at Wed Jun 1 21:53:08 2011
This example shows the information about the vFC 1 interface including attributes and status:
switch# show interface vfc 1
vfc1 is trunking (Not all VSANs UP on the trunk)
Bound interface is Ethernet1/19
Cisco Nexus 5000 Series NX-OS SAN Switching Configuration Guide, Release 5.2(1)N1(1)
82 OL-27583-01
Configuring FCoE NPV
Configuration Examples for FCoE NPV
To Next Page
Loading...
