Cisco Nexus 5000 Series - Smart Zoning Member Configuration; Enabling Smart Zoning on a VSAN; Setting Default Value for Smart Zoning

Smart Zoning Member Configuration
The following table displays the supported smart zoning member configurations.
SupportedFeature
YesPWWN
YesFCID
YesFC Alias
YesDevice-alias
NoInterface
NoIP Address
NoSymbolic nodename
NoFWNN
NoDomain ID
Enabling Smart Zoning on a VSAN
To enable smart zoning for a VSAN, perform these tasks:
SUMMARY STEPS
1.
switch# configure terminal
2.
switch(config)# system default zone smart-zone enable
DETAILED STEPS
PurposeCommand or Action
Enters global configuration mode.switch# configure terminal
Step 1
Enables smart zoning on a VSAN that are created based on
the specified default value.
switch(config)# system default zone smart-zone
enable
Step 2
Setting Default Value for Smart Zoning
To set the default value, perform these tasks:
Cisco Nexus 5000 Series NX-OS SAN Switching Configuration Guide, Release 5.2(1)N1(1)
152 OL-27583-01
Configuring and Managing Zones
Smart Zoning Member Configuration