Cisco Nexus 5500 Series - description (interface)

when no configuration is present. So setup always assumes system
defaults and not the current system configuration values.
Press Enter at anytime to skip a dialog. Use ctrl-c at anytime
to skip the remaining dialogs.
Would you like to enter the basic configuration dialog (yes/no): yes
The setup utility guides you through the basic configuration process. Press Ctrl-C at any prompt to end the configuration
process.
Step 4
Enter the new password for the administrator (admin is the default).
Example:
Enter the password for admin: admin
Step 5
Enter yes (no is the default) to create additional accounts.
Example:
Create another login account (yes/no) [n]: yes
While configuring your initial setup, you can create an additional user account (in the network-admin role) besides the
administrator's account.
a) Enter the user login ID.
Example:
Enter the user login ID: user_name
b) Enter the user password.
Example:
Enter the password for user_name: user-password
Step 6
Enter yes (yes is the default) to create an SNMP read-only community string.
Example:
Configure read-only SNMP community string (yes/no) [n]:yes
SNMP community string: snmp_community
Step 7
Enter a name for the switch.
Starting with Cisco NX-OS Release 7.3(0)N1(1), the character limit of a switch name is increased from 32 to
63 alphanumeric characters. Also, 63 characters is the maximum length limit for setting hostname using SNMP.
The default name is switch.
Note
Example:
Enter the switch name: switch_name
Step 8
Enter yes (yes is the default) to configure out-of-band management and enter the mgmt0 IPv4 address.
Example:
Continue with Out-of-band (mgmt0) management configuration? [yes/no]: yes
Mgmt0 IPv4 address: ip_address
Cisco Nexus 5500 Series NX-OS Fundamentals Configuration Guide, Release 7.x
24 OL-30890-01
Using the Cisco NX-OS Setup Utility
Initial Configuration