Cisco Nexus 5500 Series - Show Cdp Interface

1270
Cisco Nexus 5500 Series NX-OS Layer 2 Interfaces Command Reference
OL-27880-02
Chapter Show Commands
show cdp interface
show cdp interface
To display the Cisco Discovery Protocol (CDP) parameters for an interface, use the show cdp interface
command.
show cdp interface {ethernet slot/[QSFP-module/]port | mgmt mgmt-num}
Syntax Description
Command Default None
Command Modes EXEC mode
Command History
Examples This example shows how to display the CDP parameters for an Ethernet interface:
switch# show cdp interface ethernet 1/30
Ethernet1/30 is down
CDP enabled on interface
Refresh time is 60 seconds
Hold time is 180 seconds
switch#
This example shows how to display the CDP parameters for a management interface:
switch# show cdp interface mgmt 0
mgmt0 is up
CDP enabled on interface
Refresh time is 60 seconds
Hold time is 180 seconds
switch#
Related Commands
ethernet slot/[QSFP-module/]port Specifies an Ethernet interface. The slot number is from 1 to 255.
The QSFP-module number is from 1 to 4. The port number is
from 1 to 128.
Note The QSFP-module number applies only to the QSFP+
Generic Expansion Module (GEM).
mgmt mgmt-num Specifies a management interface. The management interface
number is 0.
Release Modification
6.0(2)N1(1) Support for the QSFP+ GEM was added.
5.2(1)N1(1) This command was introduced.
Command Description
cdp Enables CDP on the switch.