Cisco Nexus 5500 Series - Page 315

1309
Cisco Nexus 5500 Series NX-OS Layer 2 Interfaces Command Reference
OL-27880-02
Chapter Show Commands
show interface vethernet
show interface vethernet
To display information about a virtual Ethernet (vEth) interface configuration, use the show interface
vethernet command.
show interface vethernet veth-id [brief | description | detail | mac-address | status | switchport
| trunk]
Syntax Description
Command Default None
Command Modes EXEC mode
Command History
Examples This example shows how to display the configuration information of a specified virtual Ethernet
interface:
switch# show interface vethernet 1
Vethernet1 is down (nonParticipating)
Bound Interface is --
Hardware is Virtual, address is 0005.9b74.a6c0
Port mode is access
Speed is auto-speed
Duplex mode is auto
300 seconds input rate 0 bits/sec, 0 packets/sec
300 seconds output rate 0 bits/sec, 0 packets/sec
Rx
0 unicast packets 0 multicast packets 0 broadcast packets
0 input packets 0 bytes
0 input packet drops
Tx
0 unicast packets 0 multicast packets 0 broadcast packets
0 output packets 0 bytes
0 flood packets
0 output packet drops
veth-id Virtual Ethernet interface number. The range is from 1 to 1,048,575.
brief (Optional) Displays brief information about the vEth interface.
description (Optional) Displays the vEth interface description.
detail (Optional) Displays detailed configuration information about the vEth
interface.
mac-address (Optional) Displays the MAC address of the vEth interface.
status (Optional) Displays the vEth interface line status.
switchport (Optional) Displays the vEth interface switchport information.
trunk (Optional) Displays the vEth interface trunk information.
Release Modification
5.2(1)N1(1) This command was introduced.