Cisco Nexus 5500 Series - Show Ip Igmp Snooping

1316
Cisco Nexus 5500 Series NX-OS Layer 2 Interfaces Command Reference
OL-27880-02
Chapter Show Commands
show ip igmp snooping
show ip igmp snooping
To display the Internet Group Management Protocol (IGMP) snooping configuration of the switch, use
the show ip igmp snooping command.
show ip igmp snooping [explicit-tracking vlan vlan-id | groups [detail | vlan vlan-id] | mrouter
[vlan vlan-id] | querier [vlan vlan-id] | vlan vlan-id]
Syntax Description
Command Default None
Command Modes EXEC mode
Command History
Examples This example shows how to display the IGMP snooping configuration of the switch:
switch# show ip igmp snooping
Global IGMP Snooping Information:
IGMP Snooping enabled
IGMPv1/v2 Report Suppression enabled
IGMPv3 Report Suppression disabled
Link Local Groups Suppression enabled
IGMP Snooping information for vlan 1
IGMP snooping enabled
IGMP querier none
Switch-querier disabled
IGMPv3 Explicit tracking enabled
IGMPv2 Fast leave disabled
IGMPv1/v2 Report suppression enabled
IGMPv3 Report suppression disabled
Link Local Groups suppression enabled
Router port detection using PIM Hellos, IGMP Queries
Number of router-ports: 1
Number of groups: 0
VLAN vPC function enabled
Active ports:
explicit-tracking (Optional) Displays information about the explicit host-tracking status for
IGMPv3 hosts. If you provide this keyword, you must specify a VLAN.
vlan vlan-id (Optional) Specifies a VLAN. The VLAN ID range is from1 to 4094.
groups (Optional) Displays information for the IGMP group address.
detail (Optional) Displays detailed information for the group.
mrouter (Optional) Displays information about dynamically detected multicast
routers.
querier (Optional) Displays information about the snooping querier if defined.
Release Modification
5.2(1)N1(1) This command was introduced.