Cisco Nexus 5500 Series - Page 34

128
Cisco Nexus 5500 Series NX-OS Layer 2 Interfaces Command Reference
OL-27880-02
Chapter C Commands
clock protocol
clock protocol
To set the synchronization protocol for the clock to a protocol, use the clock protocol command. To
remove the clock protocol, use the no form of this command.
clock protocol {none | ntp}
no clock protocol {none | ntp}
Syntax Description
Command Default None
Command Modes Global configuration mode
Command History
Usage Guidelines This command does not require a license.
Examples This example shows how to set the synchronization protocol for the clock to NTP:
switch# configure terminal
switch(config)# clock protocol ntp
switch(config)#
Related Commands
none Specifies that the clock can be set manually.
ntp Specifies that the clock be set to the Network Time Protocol (NTP).
Release Modification
5.2(1)N1(1) This command was introduced.
Command Description
show running-config Displays the running system configuration information.