Cisco Nexus 5500 Series - Page 44

138
Cisco Nexus 5500 Series NX-OS Layer 2 Interfaces Command Reference
OL-27880-02
Chapter D Commands
destination (ERSPAN)
destination (ERSPAN)
To configure an Encapsulated Remote Switched Port Analyzer (ERSPAN) destination IP address, use
the destination command. To remove the destination ERSPAN IP address, use the no form of this
command.
destination ip ip_address
no destination ip ip_address
Syntax Description
Command Default None
Command Modes ERSPAN session configuration mode
Command History
Usage Guidelines You can configure only one destination IP address for an ERSPAN source session.
This command does not require a license.
Examples This example shows how to configure an ERSPAN destination IP address:
switch# configure terminal
switch(config)# monitor session 1 type erspan-source
switch(config-erspan-src)# destination ip 192.0.3.1
switch(config-erspan-src)#
Related Commands
ip Configures the remote IP address.
ip_address IPv4 address in the format A.B.C.D.
Release Modification
5.2(1)N1(1) This command was introduced.
Command Description
monitor session Creates a new SPAN session configuration.
show monitor session Displays SPAN session configuration information.
show running-config
monitor
Displays the running configuration information of a SPAN session.
source (SPAN session) Configures a source SPAN port.
source (ERSPAN
session)
Configures a source VLAN or VSAN interface.