Cisco Nexus 5500 Series - Errdisable Detect Cause

147
Cisco Nexus 5500 Series NX-OS Layer 2 Interfaces Command Reference
OL-27880-02
Chapter E Commands
errdisable detect cause
errdisable detect cause
To enable error-disable (err-disabled) detection in an application, use the errdisable detect cause
command. To disable error disable detection, use the no form of this command.
errdisable detect cause {all | link-flap | loopback}
no errdisable detect cause {all | link-flap | loopback}
Syntax Description
Command Default Enabled
Command Modes Global configuration mode
Command History
Usage Guidelines When error disable detection is enabled and a cause is detected on an interface, the interface is placed
in an err-disabled state, which is an operational state that is similar to the link-down state.
Examples This example shows how to enable the err-disabled detection on linkstate-flapping:
switch(config)# errdisable detect cause link-flap
switch(config)#
Related Commands
all Enables error detection on all cases.
link-flap Enables error disable detection on linkstate-flapping.
loopback Enables error disable detection on loopback.
Release Modification
5.2(1)N1(1) This command was introduced.
Command Description
errdisable recovery Configures recovery from the err-disabled state.
show interface status
err-disabled
Displays the interface error disabled state.