Cisco Nexus 5600 Series - Page 170

166
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
OL-31626-01
Chapter I Commands
ip igmp robustness-variable
ip igmp robustness-variable
To configure a robustness count that you can tune to reflect expected packet loss on a congested network,
use the ip igmp robustness-variable command. To reset the count to the default, use the no form of this
command.
ip igmp robustness-variable count
no ip igmp robustness-variable [count]
Syntax Description
Command Default The robustness count is 2.
Command Modes Interface configuration mode
Supported User Roles network-admin
vdc-admin
Command History
Usage Guidelines This command does not require a license.
Examples This example shows how to configure a robustness count:
switch(config)# interface ethernet 2/2
switch(config-if)# ip igmp robustness-variable 3
switch(config-if)#
This example shows how to reset a robustness count to the default:
switch(config)# interface ethernet 2/2
switch(config-if)# no ip igmp robustness-variable
switch(config-if)#
Related Commands
count Robustness count. The range is from 1 to 7. The default is 2.
Release Modification
6.0(2)N1(1) This command was introduced.
Command Description
show ip igmp interface Displays IGMP information about the interface.