Cisco Nexus 5600 Series - Page 23

Show Commands
show forwarding distribution ipv6 multicast route
MCR-19
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
OL-31626-01
show forwarding distribution ipv6 multicast route
To display information about the multicast IPv6 FIB routes, use the show forwarding distribution ipv6
multicast route command.
show forwarding distribution ipv6 multicast route [table table_id | vrf vrf-name] [group [source]
| summary]
Syntax Description
Defaults None
Command Modes Any command mode
Supported User Roles network-admin
network-operator
vdc-admin
vdc-operator
Command History
Usage Guidelines This command does not require a license.
Examples This example shows how to display information about the multicast IPv6 FIB routes:
switch(config)# show forwarding distribution ipv6 multicast route
IPv6 Multicast Routing table table-id:0x80000001
Total number of groups: 5
Legend:
C = Control Route
D = Drop Route
G = Local Group (directly connected receivers)
O = Drop on RPF Fail
P = Punt to supervisor
table table_id (Optional) Specifies a table ID. The range is from 0x0 to 0xffffffff.
vrf vrf-name (Optional) Specifies a virtual routing and forwarding (VRF) name. The name can be
a maximum of 32 alphanumeric characters.
group (Optional) IPv6 group address.
source (Optional) IPv6 source address.
summary (Optional) Specifies route counts.
Release Modification
5.0(3)N1(1) This command was introduced.