Cisco Nexus 5600 Series - Page 250

246
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
OL-31626-01
Chapter I Commands
ip msdp group-limit
ip msdp group-limit
To configure the Multicast Source Discovery Protocol (MSDP) maximum number of (S, G) entries that
the software creates for the specified prefix, use the ip msdp group-limit command. To remove the
group limit, use the no form of this command.
ip msdp group-limit limit source prefix
no ip msdp group-limit limit source prefix
Syntax Description
Command Default None
Command Modes Global configuration mode
Supported User Roles network-admin
vdc-admin
Command History
Usage Guidelines This command requires the LAN Base Services license.
Examples This example shows how to configure the maximum number of (S, G) entries to create for a source:
switch(config)# ip msdp group-limit 4000 source 192.168.1.0/24
This example shows how to remove the limit entries to create:
switch(config)# no ip msdp group-limit 4000 source 192.168.1.0/24
Related Commands
limit Limit on number of groups. The range is from 0 to 4294967295. The default is no
limit.
source prefix Specifies the prefix to match sources against.
Release Modification
6.0(2)N1(1) This command was introduced.
Command Description
show ip msdp sources Displays information about the MSDP learned sources and group limit.