Cisco Nexus 5600 Series - Page 272

268
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
OL-31626-01
Chapter Show Commands
show ip msdp policy statistics sa-policy
show ip msdp policy statistics sa-policy
To display information about Multicast Source Discovery Protocol (MSDP) Source-Active (SA)
policies, use the show ip msdp policy statistics sa-policy command.
show ip msdp policy statistics sa-policy peer-address {in | out} [vrf {vrf-name}]
Syntax Description
Command Default None
Command Modes Any command mode
Supported User Roles network-admin
network-operator
vdc-admin
vdc-operator
Command History
Usage Guidelines This command requires the LAN Base Services license.
Examples This example shows how to display information about MSDP SA policies:
switch(config)# show ip msdp policy statistics sa-policy 192.168.1.10 in
peer-address IP address of the MSDP peer for the SA policy.
in Specifies the input policy.
out Specifies the output policy.
vrf (Optional) Applies to a virtual routing and forwarding (VRF) instance.
vrf-name VRF name. The name can be a maximum of 32 alphanumeric characters and is case
sensitive.
Release Modification
6.0(2)N1(1) This command was introduced.