351
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
OL-31626-01
Chapter I Commands
ip pim rp-candidate
Note Use the same configuration guidelines for the route-map auto-rp-range that you used when you created
a route map for static RPS.
This command requires the LAN Base Services license.
Examples This example shows how to configure the router as a PIM BSR RP candidate:
switch(config)# ip pim rp-candidate e 2/11 group-list 239.0.0.0/24
This example shows how to remove the router as an RP candidate:
switch(config)# no ip pim rp-candidate
Related Commands Command Description
show ip pim rp Displays information about PIM RPs.
To Next Page
Loading...
