Cisco Nexus 5600 Series - ipv6 pim sparse-mode

394
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
OL-31626-01
Chapter I Commands
ipv6 pim rp-address
ipv6 pim rp-address
To configure an IPv6 Protocol Independent Multicast (PIM6) static route processor (RP) address for a
multicast group range, use the ipv6 pim rp-address command. To remove a static RP address, use the
no form of this command.
ipv6 pim rp-address rp-address [group-list prefix | route-map policy-name] [bidir]
no ipv6 pim rp-address rp-address [group-list prefix | route-map policy-name] [bidir]
Syntax Description
Defaults The group range is treated in ASM mode.
Command Modes Global configuration mode
VRF configuration mode
Supported User Roles network-admin
vdc-admin
Command History
Usage Guidelines The match ipv6 multicast command is the only match command that is evaluated in the route map. You
can specify the group prefix to filter messages with the match ipv6 multicast command.
This command requires the Enterprise Services license.
Examples This example shows how to configure a PIM6 static RP address for a group range:
switch(config)# ipv6 pim rp-address 2001:0db8:0:abcd::1 group-list ff1e:abcd:def1::0/96
This example shows how to remove a static RP address:
switch(config)# no ipv6 pim rp-address 2001:0db8:0:abcd::1
rp-address IPv6 address of the router, which is the RP for the group range.
group-list
prefix
(Optional) Specifies a group range for a static RP.
route-map
policy-name
Specifies the route-map policy name.
bidir (Optional) Specifies to handle group ranges in PIM6 bidirectional (Bidir) mode.
Release Modification
5.0(3)N1(1) This command was introduced.
4.2(1) Added the keyword route-map and argument policy-name.