Cisco Nexus 5600 Series - Page 454

450
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
OL-31626-01
Chapter Show Commands
show ipv6 pim neighbor
show ipv6 pim neighbor
To display information about IPv6 Protocol Independent Multicast (PIM6) neighbors, use the show ipv6
pim neighbor command.
show ipv6 pim neighbor {[if-type if-number] | [neighbor-addr]} [vrf {vrf-name | all}]
Syntax Description
Defaults None
Command Modes Any command mode
Supported User Roles network-admin
network-operator
vdc-admin
vdc-operator
Command History
Usage Guidelines This command requires the Enterprise Services license.
Examples This example shows how to display information about PIM6 neighbors:
switch(config)# show ipv6 pim neighbor
PIM6 Neighbor Status for VRF "default"
Neighbor Address Interface Uptime Expires DR Bidir
Pri
fe80::0230:48ff:fe34:0d67 Eth2/1 00:00:39 00:01:34 1 yes
Secondary addresses:
0001::0002
switch(config)#
if-type (Optional) Interface type. For more information, use the question mark (?) online
help function.
if-number (Optional) Interface or subinterface number. For more information about the
numbering syntax for your networking device, use the question mark (?) online help
function.
neighbor-addr (Optional) IPv6 address of a neighbor.
vrf (Optional) Applies to a virtual routing and forwarding (VRF) instance.
vrf-name VRF name. The name can be a maximum of 32 alphanumeric characters and is case
sensitive.
all Specifies all VRFs.
Release Modification
5.0(3)N1(1) This command was introduced.