Show Commands
show ip pim rp
MCR-85
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
OL-31626-01
show ip pim rp
To display information about the rendezvous points (RPs) for IPv4 Protocol Independent Multicast
(PIM), use the show ip pim rp command.
show ip pim rp [group] [vrf {vrf-name | all | default | management}]
Syntax Description
Command Default None
Command Modes Any command mode
Supported User Roles network-admin
network-operator
vdc-admin
vdc-operator
Command History
Usage Guidelines This command requires the LAN Base Services license.
Examples This example shows how to display information about IPv4 PIM RPs:
switch(config)# show ip pim rp
PIM RP Status Information for VRF "default"
BSR disabled
Auto-RP disabled
BSR RP Candidate policy: None
BSR RP policy: None
Auto-RP Announce policy: None
Auto-RP Discovery policy: None
switch(config)#
group (Optional) Group address.
vrf (Optional) Applies to a virtual routing and forwarding (VRF) instance.
vrf-name VRF name. The name can be a maximum of 32 alphanumeric characters and is case
sensitive.
all Specifies all VRFs.
default Specifies the default VRF.
management Specifies the management VRF.
Release Modification
5.0(3)N1(1) This command was introduced.
To Next Page
Loading...
