Cisco Nexus 5600 Series - Page 91

Show Commands
show ip pim rp-hash
MCR-87
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
OL-31626-01
show ip pim rp-hash
To display information about the RP-hash values for IPv4 Protocol Independent Multicast (PIM), use the
show ip pim rp-hash command.
show ip pim rp-hash group [vrf {vrf-name | all | default | management}]
Syntax Description
Command Default None
Command Modes Any command mode
Supported User Roles network-admin
network-operator
vdc-admin
vdc-operator
Command History
Usage Guidelines This command requires the LAN Base Services license.
Examples This example shows how to display information about IPv4 PIM RP-hash values:
switch(config)# show ip pim rp-hash 224.1.1.1
group Group address for RP lookup.
vrf (Optional) Applies to a virtual routing and forwarding (VRF) instance.
vrf-name VRF name. The name can be a maximum of 32 alphanumeric characters and is case
sensitive.
all Specifies all VRFs.
default Specifies the default VRF.
management Specifies the management VRF.
Release Modification
5.0(3)N1(1) This command was introduced.