Show Commands
show ip pim statistics
MCR-88
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
OL-31626-01
show ip pim statistics
To display information about the packet counter statistics for IPv4 Protocol Independent Multicast
(PIM), use the show ip pim statistics command.
show ip pim statistics [vrf {vrf-name | all | default | management}]
Syntax Description
Command Default None
Command Modes Any command mode
Supported User Roles network-admin
network-operator
vdc-admin
vdc-operator
Command History
Usage Guidelines This command requires the LAN Base Services license.
Examples This example shows how to display information about IPv4 PIM statistics (if PIM is not in vPC mode,
the vPC statistics are not displayed):
switch(config)# show ip pim statistics
PIM Global Counter Statistics for VRF:default, last reset: never
Register processing (sent/received):
Registers: 0/0, Null registers: 0/0, Register-Stops: 0/0
Registers received and not RP: 0
Registers received for SSM groups: 0
BSR processing (sent/received):
Bootstraps: 0/0, Candidate-RPs: 0/0
BSs from non-neighbors: 0, BSs from border interfaces: 0
BS length errors: 0, BSs which RPF failed: 0
vrf (Optional) Applies to a virtual routing and forwarding (VRF) instance.
vrf-name VRF name. The name can be a maximum of 32 alphanumeric characters and is case
sensitive.
all Specifies all VRFs.
default Specifies the default VRF.
management Specifies the management VRF.
Release Modification
5.0(3)N1(1) This command was introduced.
4.1(3) Changed output to include vPC information when PIM is in vPC mode.
To Next Page
Loading...
