Cisco Nexus 7000 Series - Displaying VRRP Statistics; VRRP Example Configuration

Send document comments to nexus7k-docfeedback@cisco.com.
20-20
Cisco Nexus 7000 Series NX-OS Unicast Routing Configuration Guide, Release 4.x
OL-20002-02
Chapter 20 Configuring VRRP
Displaying VRRP Statistics
Displaying VRRP Statistics
To display VRRP statistics, use the following commands:
Use the clear vrrp statistics command to clear all the VRRP statistics for all interfaces in the device.
Use the clear vrrp vr command to clear the IPv4 VRRP statistics for a specified interface.
Use the clear vrrp ipv4 command to clear all the statistics for the specified IPv4 virtual router.
VRRP Example Configuration
In this example, Router A and Router B each belong to three VRRP groups. In the configuration, each
group has the following properties:
• Group 1:
– Virtual IP address is 10.1.0.10.
– Router A will become the master for this group with priority 120.
– Advertising interval is 3 seconds.
– Preemption is enabled.
• Group 5:
– Router B will become the master for this group with priority 200.
– Advertising interval is 30 seconds.
– Preemption is enabled.
• Group 100:
– Router A will become the master for this group first because it has a higher IP address
(10.1.0.2).
– Advertising interval is the default 1 second.
– Preemption is disabled.
Router A
interface ethernet 1/0
ip address 10.1.0.2/16
show vrrp vr number interface interface-type
port configuration
Displays the virtual router configuration for an
interface.
show vrrp vr number interface interface-type
port status
Displays the virtual router status for an interface.
Command Purpose
Command Purpose
show vrrp vr number interface interface-type
port statistics
Displays the virtual router information.
show vrrp statistics Displays the VRRP statistics.