Figure 4: Standard Hardware Features on the Front and Sides of the Cisco Nexus 7010 Chassis
Handles used to reposition the chassis (do not lift
the chassis with these handles—use a mechanical
lift)
5Door for the cable management area1
I/O or NAM modules (1 to 8 modules in slots 1
to 4 and 7 to 10).
6System status LEDs2
Supervisor modules (1 or 2 modules in slots 5
and 6). These modules are of only one of the
following types (if installing two supervisor
modules, both modules must be the same type
with the same amount of memory):
• Supervisor 1 (N7K-SUP1)
• Supervisor 2 (N7K-SUP2)
• Supervisor 2 Enhanced (N7K-SUP2E)
7Cable management area (upper routing portion
can be removed if necessary)
3
Air intake (shown without the optional air filter)8Rack-mount bracket (2) (one on each side)4
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
9
Overview
Cisco Nexus 7010 System
To Next Page
Loading...
