Cisco Nexus 7706 - Cisco Nexus 7706 Switch Center-Mount Rails Kit

All power cords will not be orderable at first customer shipment (FCS).
Note
The available DC power cords for the 3.5-kW HVAC/HVDC power supplies are as follows:
• CAB-HV-25A-SG-US1—power cord, 400-VDC 20A, Saf-D-Grid/Saf-D-Grid, North America
• CAB-HV-25A-SG-US2—power cord, 300-VAC/500-VDC 20A, Ring Terminal/Saf-D-Grid, North
America
• CAB-HV-25A-SG-IN1—power cord, 400-VDC 20A, IEC/EU, Saf-D-Grid/Saf-D-Grid, International
• CAB-HV-25A-SG-IN2—power cord, 300-VAC/500-VDC 20A, IEC/EU, Ring Terminal/Saf-D-Grid,
International
All power cords will not be orderable at first customer shipment (FCS).
Note
Cisco Nexus 7706 Switch Center-Mount Rails Kit
The Center-Mount Kit is not included in the accessory kit, but, if you are centering the chassis on a two-post
rack, you must order this kit (part number N7K-C7706-CMK=) when you order the switch. The following
table lists the contents for this kit.
QuantityDescription
2Center-mount rack mounting brackets (right and left
brackets)
2Center-mount bottom support rails (right and left rails)
1Crossbar
2012-24 x 3/4-in. Phillips screws
20M6 x 19-mm Phillips screws
2M4 x 8-mm screws
Cisco Nexus 7706 Hardware Installation Guide
OL-31330-01170
Accessory Kits
Cisco Nexus 7706 Switch Center-Mount Rails Kit