Cisco Nexus 9000 Series - Page 71

2. radius-server host {ipv4-address | ipv6-address | hostname}
3. (Optional) show radius {pending | pending-diff}
4. (Optional) radius commit
5. exit
6. (Optional) show radius-server
7. (Optional) copy running-config startup-config
DETAILED STEPS
PurposeCommand or Action
Enters global configuration mode.configure terminal
Example:
Step 1
switch# configure terminal
switch(config)#
Specifies the IPv4 or IPv6 address or hostname for a
RADIUS server to use for authentication.
radius-server host {ipv4-address | ipv6-address |
hostname}
Example:
Step 2
switch(config)# radius-server host 10.10.1.1
Displays the RADIUS configuration pending for
distribution.
(Optional) show radius {pending | pending-diff}
Example:
Step 3
switch(config)# show radius pending
Applies the RADIUS configuration changes in the
temporary database to the running configuration.
(Optional) radius commit
Example:
Step 4
switch(config)# radius commit
Exits configuration mode.exit
Example:
Step 5
switch(config)# exit
switch#
Displays the RADIUS server configuration.(Optional) show radius-server
Example:
Step 6
switch# show radius-server
Copies the running configuration to the startup
configuration.
(Optional) copy running-config startup-config
Example:
Step 7
switch# copy running-config startup-config
Related Topics
Configuring a Key for a Specific RADIUS Server, on page 47
Cisco Nexus 9000 Series NX-OS Security Configuration Guide, Release 9.x
45
Configuring RADIUS
Configuring RADIUS Server Hosts