Cisco Nexus 9000 Series - Page 77

PurposeCommand or Action
Verifies the VRF configuration for this
routing protocol.
switch# show running-config eigrp
Example:
switch# show running-config eigrp
version 6.1(2)I1(1)
Step 3
feature eigrp
router eigrp 99
address-family ipv4 unicast
router-id 192.0.2.1
vrf red
stub
Checks the memory utilization for this
routing protocol.
switch# show processes memory | include isis
Example:
switch# show processes memory | include isis
8913 9293824 bffff1d0/bffff0d0 isis
32243 8609792 bfffe0c0/bfffdfc0 isis
Step 4
Verifies that the routing protocol is receiving
packets.
switch# show ip client pim
Example:
switch# show ip client pim
Client: pim, uuid: 284, pid: 3839, extended pid: 3839
Step 5
Protocol: 103, client-index: 10, routing VRF id: 255
Data MTS-SAP: 1519
Data messages, send successful: 2135, failed: 0
Verifies that the routing protocol is enabled
on an interface.
switch# show ip interface loopback-interface
Example:
switch# show ip interface loopback0
loopback0, Interface status: protocol-up/link-up/admin-up,
Step 6
iod: 36, Context:"default"
IP address: 1.0.0.1, IP subnet: 1.0.0.0/24
...
IP multicast groups locally joined:
224.0.0.2 224.0.0.1 224.0.0.13
...
Verifies that the interface is in the correct
VRF.
switch# show vrf interface loopback -interface
Example:
switch# show vrf interface loopback 99
Interface VRF-Name
Step 7
VRF-ID
loopback99 default
1
Verifies that the routing protocol is registered
with the RIB.
switch# show routing unicast clients
Example:
switch# show routing unicast clients
Step 8
Verifies that the RIB is interacting with the
forwarding plane.
switch# show forwarding distribution multicast client
Example:
switch# show forwarding distribution multicast client
Number of Clients Registered: 3
Step 9
Client-name Client-id Shared Memory Name
Cisco Nexus 9000 Series NX-OS Troubleshooting Guide, Release 7.x
65
Troubleshooting Routing
Troubleshooting Routing