Cisco Nexus 93108TC-FX3 - Installing the Cisco Nexus Switch Chassis; General Safety Instructions for Installation

CHAPTER 3
Installing the Switch Chassis
• Safety, on page 11
• Installation Options with Rack-Mount Kits, on page 15
• Airflow Considerations, on page 15
• Installation Guidelines, on page 15
• Unpacking and Inspecting the Switch, on page 16
• Installing the Switch Using the NXK-ACC-KIT-1RU Rack-Mount Kit, on page 17
• Installing the Switch into a Two-Post Rack Using the NXK-ACC-KIT-1RU Rack-Mount Kit, on page
20
• Installing the Airflow Sleeve (N9K-AIRFLOW-SLV), on page 24
• Grounding the Chassis, on page 25
• Starting the Switch, on page 26
Safety
Before you install, operate, or service the switch, see the Regulatory, Compliance, and Safety Information for
the Cisco Nexus 3000 and 9000 Series for important Safety Information.
Statement 1071—Warning Definition
IMPORTANT SAFETY INSTRUCTIONS
Before you work on any equipment, be aware of the hazards involved with electrical circuitry and be familiar
with standard practices for preventing accidents. Read the installation instructions before using, installing, or
connecting the system to the power source. Use the statement number provided at the end of each warning
statement to locate its translation in the translated safety warnings for this device.
SAVE THESE INSTRUCTIONS
Warning
Cisco Nexus 93108TC-FX3 ACI-Mode Switch Hardware Installation Guide
11