Cisco Nexus 93180YC-FX - Page 12

All fan modules and power supplies must use the same airflow direction during
operations. If you are using the 1200-W HVAC/HVDC power supply, the power supply
automatically uses the same airflow direction as used by the other modules in the switch.
Note
The following figure shows the hardware features seen from the port side of the chassis.
Screw holes (6) for attaching
rack mounting brackets.
4Chassis LEDs (Beacon [BCN], Status [STS], and Environment
[ENV])
1
Screw holes (2) for attaching
grounding lug.
548 10/25-Gigabit SFP28 ports to2
6 40/100-Gigabit QSFP28 optical ports for uplink connections
to
3
To determine which transceivers, adapters, and cables are supported by this switch, see the Cisco Transceiver
Modules Compatibility Information document.
The following figure shows the hardware features seen from the power supply side of the chassis.
Console port (RS232 port)6Two power supplies (one used for operations and
one used for redundancy) (AC power supplies
shown) with power supply slot 1 on the left and
slot 2 on the right
1
USB port used for saving or copying functions7Four fan modules with fan slot 1 on the left and
fan slot 4 on the right
2
Cisco Nexus 93180YC-FX NX-OS Mode Switch Hardware Installation Guide
2
Overview
Overview