CHAPTER 4
Connecting the Switch to the ACI Fabric
• ACI Fabric Topology, on page 29
• Preparing to Connect to Other Devices, on page 30
• Connecting Leaf Switches to APICs, on page 31
• Connecting Leaf Switches to Spine Switches, on page 32
• Setting Up an Optional Console Interface, on page 33
• Setting Up an Optional Management Connection, on page 34
• Maintaining Transceivers and Optical Cables, on page 35
ACI Fabric Topology
The ACI fabric topology includes the following major components:
• Application Centric Infrastructure Controller (APIC) appliance (cluster of APICs)
• Leaf switches (for switch compatibility, please see the data sheets here: https://www.cisco.com/c/en/us/
products/switches/nexus-9000-series-switches/datasheet-listing.html
• Spine switches (for switch compatibility, please see the data sheets here: https://www.cisco.com/c/en/
us/products/switches/nexus-9000-series-switches/datasheet-listing.html
As shown in the following figure, each APIC is connected to one or two leaf switches and each leaf switch
should be connected to every spine switch in the same fabric.
To prevent sub-optimal forwarding between endpoints, connect every leaf switch in the fabric to every spine
switch in the same fabric.
Note
Cisco Nexus 9348GC-FXP ACI Mode Hardware Installation Guide
29
To Next Page
Loading...
