Cisco Nexus 9408 - Displaying the Modules for the Switch

NAME: "Power Supply 3", DESCR: "Nexus9000 C9408 Chassis Power Supply"
PID: NXA-PAC-2KW-PI , VID: V01 , SN: POG2547JAH6
NAME: "Power Supply 4", DESCR: "Nexus9000 C9408 Chassis Power Supply"
PID: NXA-PAC-2KW-PI , VID: V01 , SN: POG2547JA20
NAME: "Fan 1", DESCR: "Nexus9000 C9408 Chassis Fan Module"
PID: N9K-C9400-FAN-PI , VID: V01 , SN: N/A
NAME: "Fan 2", DESCR: "Nexus9000 C9408 Chassis Fan Module"
PID: N9K-C9400-FAN-PI , VID: V01 , SN: N/A
NAME: "Fan 3", DESCR: "Nexus9000 C9408 Chassis Fan Module"
PID: N9K-C9400-FAN-PI , VID: V01 , SN: N/A
NAME: "Fan 4", DESCR: "Nexus9000 C9408 Chassis Fan Module"
PID: N9K-C9400-FAN-PI , VID: V01 , SN: N/A
NAME: "Fan 5", DESCR: "Nexus9000 C9408 Chassis Fan Module"
PID: N9K-C9400-FAN-PI , VID: V01 , SN: N/A
ASW4_QP_LEM#
Displaying the Modules for the Switch
You can display information about the modules, that are installed in the switch by using the show module
command.
switch# show module
Mod Ports Module-Type Model Status
--- ----- ------------------------------------- --------------------- ---------
1 0 Supervisor N9K-C9408-SUP-A active *
27 0 Virtual Supervisor Module N9K-C9400-SUP-A active *
Mod Sw Hw Slot
--- ----------------------- ------ ----
1 10.3(2) 0.4 LC1
27 10.3(2) 0.4 SUP1
Mod MAC-Address(es) Serial-Num
--- -------------------------------------- ----------
1 60-26-aa-48-c8-40 to 60-26-aa-48-c8-7f FDO262208WX
27 60-26-aa-48-c8-40 to 60-26-aa-48-c8-7f FDO262208WX
Mod Online Diag Status
--- ------------------
1 Pass
27 Pass
* this terminal session
Lem Ports Module-Type Model Status
--- ----- ------------------------------------- --------------------- ---------
1 16 16x200G Ethernet Module N9K-X9400-8D ok
2 8 8x400G Ethernet Module N9K-X9400-8D ok
4 8 8x400G Ethernet Module N9K-X9400-16W ok
Mod Sw Hw Slot
--- ----------------------- ------ ----
Cisco Nexus 9408 NX-OS Mode Switch Hardware Installation Guide
45
Managing the Switch
Displaying the Modules for the Switch