Cisco Nexus 9508 - Page 12

◦
48-port 1/10GBASE-T (copper) and 4-port 10/40-Gigabit Ethernet QSFP+ line card
(N9K-X9464TX)
◦
48-port 1/10GBASE-T (copper) and 4-port 10/40-Gigabit Ethernet QSFP+ line card
(N9K-X9464TX2)
◦
48-port 1/10-Gigabit Ethernet SFP+ and 4-port 40-Gigabit Ethernet QSFP+ line card
(N9K-X9564PX)
◦
48-port 1/10GBASE-T (copper) and 4-port 10/40-Gigabit Ethernet QSFP+ line card
(N9K-X9564TX)
◦
Line cards supported by N9K-C9508-FM-E fabric modules (For updated optics information,
see the Cisco optics matrix.)
◦
32-port 100-Gigabit Ethernet QSFP28 line card (N9K-X9732C-EX) with each port supporting
100-, 50-, 40-, 25-, 10-, and 1-Gigabit Ethernet connectivity
◦
48-port 1/10/25-Gigabit Ethernet SFP28 and 4-port 40/100-Gigabit Ethernet QSFP28 line
card (N9K-X97160YC-EX)
◦
Line cards supported by N9K-C9508-FM-R fabric modules (For updated optics information,
see the Cisco optics matrix.)
◦
36-port 100-Gigabit Ethernet QSFP28 line card (N9K-X9636C-RX) with TCAM
◦
36-port 100-Gigabit Ethernet QSFP28 line card (N9K-X9636C-R)
◦
36-port 40-Gigabit Ethernet QSFP+ line card (N9K-X9636Q-R)
◦
Line cards supported by N9K-C9508-FM-S fabric modules (For updated optics information,
see the Cisco optics matrix.)
◦
32-port 100-Gigabit Ethernet QSFP28 line card (N9K-X9432C-S) supporting 100-, 50-, 40-,
25-, 10-, 1-Gigabit Ethernet connectivity
Do not mix ACI-mode line cards with NX-OS mode line cards in the same switch.Note
•
Fabric modules in slots FM 1 to FM 6 (reported as modules 21 to 26)
See the following table for the required fabric module types and quantities.
Cisco Nexus 9508 NX-OS Mode Switch Hardware Installation Guide
2
Overview
Overview