Cisco ONS 15454 DWDM - Page 36

Figures
xxxvi
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
August 2005
Figure 17-20 Scalable Terminal Example 17-21
Figure 17-21 Amplified Hybrid Terminal Example 17-22
Figure 17-22 Passive Hybrid Terminal Example 17-23
Figure 17-23 Hybrid Amplified OADM Example 17-24
Figure 17-24 Hybrid Line Amplifier Example 17-25
Figure 17-25 Hybrid Line Amplifier Channel Flow Example 17-26
Figure 17-26 Amplified TDM Example with an OPT-BST Amplifier 17-27
Figure 17-27 Amplified TDM Channel Flow Example With OPT-BST Amplifiers 17-27
Figure 17-28 Amplified TDM Example with FlexLayer Filters 17-28
Figure 17-29 Amplified TDM Channel Flow Example With FlexLayer Filters 17-28
Figure 17-30 Amplified TDM Channel Flow Example With Amplifiers, AD-1C-xx.x Cards, and OSC-CSM Cards 17-29
Figure 17-31 WDM-ANS Provisioning 17-34
Figure 18-1 Hubbed Ring 18-2
Figure 18-2 Multihubbed Ring 18-3
Figure 18-3 Any-to-Any Ring 18-4
Figure 18-4 Meshed Ring 18-5
Figure 18-5 Linear Configuration with an OADM Node 18-5
Figure 18-6 Linear Configuration without an OADM Node 18-6
Figure 18-7 Single-Span Link 18-6
Figure 18-8 Automatic Power Control 18-21
Figure 18-9 Power Monitoring Subtab 18-22
Figure 18-10 Span Loss Verification 18-23
Figure 18-11 Nodes Using OPT-BST/OPT-BST-E Cards 18-25
Figure 18-12 Nodes Using OSC-CSM Cards 18-27
Figure 18-13 Effect of Gain Ripple and Gain Tilt on Amplifier Output Power 18-29
Figure 18-14 Flat Gain (Gain Tilt = 0 dB) 18-30
Figure 18-15 Effect of VOA Attenuation on Gain Tilt 18-30
Figure 18-16 System Tilt Compensation Without a ROADM 18-32
Figure 18-17 MetroPlanner Installation Parameters 18-33
Figure 18-18 System Tilt Compensation With a ROADM 18-34
Figure 19-1 CTC Software Versions, Node View 19-2
Figure 19-2 CTC Software Versions, Network View 19-3
Figure 19-3 Node View (Default Login View) 19-7
Figure 19-4 Terminal Loopback Indicator 19-9
Figure 19-5 Facility Loopback Indicator 19-10