Figure 67: Upgrade the ONS 15454 Multishelf with MS-ISC Card Configuration Using the Catalyst 3560
NTP-G297 Upgrade the ONS 15454 Multishelf with Catalyst 2950
Configuration Using the Catalyst 3560
Use this procedure to upgrade the existing ONS 15454 multishelf configuration
that uses the Catalyst 2950 with the Catalyst 3560
Purpose
• Two Cisco Catalyst 3560 switches must be installed in same rack as the node
controller shelf; refer to the Cisco Catalyst 3560 product documentation for
installation instructions.
• Cross-over (CAT-5) LAN cables (3, plus 2 for each subtending shelf)
Tools/Equipment
NTP-G15 Install the Common Control Cards, on page 131.Prerequisite Procedures
As neededRequired/As Needed
OnsiteOnsite/Remote
NoneSecurity Level
Cisco ONS 15454 Hardware Installation Guide
150
Installing the ONS 15454 M12 (ANSI and ETSI) Shelf
NTP-G297 Upgrade the ONS 15454 Multishelf with Catalyst 2950 Configuration Using the Catalyst 3560
To Next Page
Loading...
