Procedure
Step 1 Set the mounting brackets to the rack you are using.
Step 2 Install the right and left ANSI 23" bracket to the unit using the four washer and the screws provided with the
installation kit.
Figure 87: Right and Left ANSI 23" Bracket
Step 3 Install the right Mesh Panel unit in the ANSI 23" rack. To ensure safe unit mounting, use at least two screws
on each side.
Figure 88: Mesh Panel Unit
Cisco ONS 15454 Hardware Installation Guide
168
Installing the ONS 15454 M12 (ANSI and ETSI) Shelf
Install PP-Mesh on an ANSI 23" Configuration
To Next Page
Loading...
