Cisco ONS 15454 - Page 501

4-13
Cisco ONS 15454 Troubleshooting Guide, R8.5
November 2009
Chapter 4 Error Messages
EID-2183 The circuit roll failed.
Bridge and roll is not supported on VCAT circuits.
Refer to the error message text.
EID-2184 Spanning Tree Protocol cannot be enabled on some ports
because the ports have been assigned an incompatible list of
VLANs.
You can view the VLAN/Spanning Tree table or reassign the
Ethernet port VLANs.
Refer to the error message text.
EID-2185 The VLANs on some ports cannot be assigned because they are
incompatible with the Spanning Tree Protocol.
You can view the VLAN/Spanning Tree table or reassign the
VLANs.
Refer to the error message text.
EID-2186 The software download failed on node {0}. The software could not be downloaded onto
the specified node.
EID-2187 The ring name cannot exceed {0} characters.
Please try again.
You must shorten the length of the ring
name.
EID-2188 The nodes in this ring do not support alphanumeric IDs. Please
use a ring ID between {0} and {1}.
The ring ID should not contain
alphanumeric characters, and must be in the
specified range.
EID-2189 The TL1 keyword "all" cannot be used as the ring name.
Please provide another name.
Refer to the error message text.
EID-2190 Adding this span will cause the ring to contain more nodes than
allowed.
You have reached the maximum number of
nodes allowed.
EID-2191 The ring name must not be empty. You must supply a ring name.
EID-2192 A valid route cannot be found for the circuit creation request. CTC could not complete the circuit creation
request either because there are no physical
links, or the bandwidth of the available
links are already reserved.
EID-2193 A valid route cannot be found for the circuit drop creation
request.
Refer to the error message text.
EID-2194 A valid route cannot be found for the roll creation request. Refer to the error message text.
EID-2195 The circuit VLAN list cannot be mapped to one spanning tree.
You can view the VLAN/Spanning Tree table or reassign
VLANs.
Refer to the error message text.
EID-2196 CTC cannot be relaunched.
{0}
There is an error relaunching CTC.
EID-2197 A CORBA failure occurred. CTC cannot proceed. There was a CORBA failure, and the task
cannot proceed. Verify the Java version.
EID-2198 CTC is unable to switch to the {0} view. CTC is unable to switch to the specified
view.
EID-2199 Login failed on {0} {1} The login failed on the specified tasks.
Table 4-1 Error Messages (continued)
Error Warning
ID Error Warning Message Description