Cisco ONS 15454 - Page 503

4-15
Cisco ONS 15454 Troubleshooting Guide, R8.5
November 2009
Chapter 4 Error Messages
EID-2221 A valid route cannot be found for the unprotected to {0}
upgrade request.
Refer to the error message text.
EID-2222 One or more of the following nodes are currently part of a
four-fiber {0}. Only a single four-fiber {0} is supported per
node.
{1}
The nodes, specified by {1}, are already
part of a 4-fiber BLSR/MS-SPRing type
(specified by {0}).
EID-2223 Only one circuit can be upgraded at a time. Refer to the error message text.
EID-2224 This link may not be included because it terminates on the
source.
Refer to the error message text.
EID-2225 A valid signal could not be detected while trying to complete
the roll.
{0}
Roll can be completed only when a valid
signal is detected. If not, the roll completion
may result in an error.
EID-2226 The circuit roll failed.
{0}
Refer to the error message text.
EID-2320 This VCAT circuit does not support deletion of its member
circuits.
You can not delete a circuit that is a member
of VCAT circuit.
EID-2321 An error occurred while deleting member circuits.
{0}
Refer to the error message text.
WID-2322 Not all cross-connects from selected circuits could be merged
into the current circuit. They might appear as partial circuits.
Refer to the warning message text.
EID-2323 The circuit roll failed.
Bridge and roll is not supported on monitor circuits.
A monitor circuit does not support Bridge
and Roll.
EID-2324 An error occurred during the circuit upgrade.
{0}
Refer to the error message text.
EID-2325 You have failed {0} times to unlock this session. CTC will exit
after you click OK or close this dialog box.
The maximum amount of attempts to
unlock this session has been reached.
WID-2326 Currently, CTC does not support bridge and roll on circuits that
are entirely created by TL1. To continue with bridge and roll in
CTC, the selected circuits must be upgraded.
Is it OK to upgrade the selected circuits and continue the bridge
and roll operation?
Refer to the warning message text.
WID-2327 Currently, CTC does not support bridge and roll on circuits that
are partially created by TL1. To continue with bridge and roll
in CTC, the selected circuits must be upgraded.
Is it OK to upgrade the selected circuits and continue the bridge
and roll operation?
Refer to the warning message text.
EID-2328 An error occurred during the circuit reconfiguration.
{0}
The attempt to reconfigure the specified
circuit has failed.
EID-2329 {0} of {1} circuits could not be successfully created. A few circuits could not be created.
EID-2330 An error occurred during circuit verification. The selected {0}
is invalid!
{1}
The selected item, specified by {0}, is
invalid as per the details, specified in {1}.
Table 4-1 Error Messages (continued)
Error Warning
ID Error Warning Message Description