4-16
Cisco ONS 15454 Troubleshooting Guide, R8.5
November 2009
Chapter 4 Error Messages
EID-2331 Deleting {0} might be service affecting. Deleting the item can affect the service of
CTC.
EID-2332 A validation error occurred in row {0}.
{1} hold-off timer for {2} must be between {3}-10,000 ms, in
steps of 100 ms.
Refer to the error message text.
EID-3001 An Ethernet RMON threshold with the same parameters
already exists. Please change one or more of the parameters and
try again.
Change a few parameters in an Ethernet
remote monitoring (RMON) threshold and
try again.
EID-3002 An error occurred while retrieving defaults from the node: {0} There was an error while retrieving the
defaults from the specified node.
EID-3003 The file {0} cannot be loaded. CTC cannot load the specified file.
EID-3004 Properties cannot be loaded from the node. Refer to the error message text.
EID-3005 NE update properties cannot be saved to the file {0}. CTC cannot save the network element (NE)
update values to the specified file.
EID-3006 NE update properties cannot be loaded from the node. Refer to the error message text.
EID-3007 An error occurred while provisioning the {0}. There was a provisioning error for the
specified item.
EID-3008 This is not a valid card. You cannot perform DWDM automatic
node setup (ANS) from the Card view.
Please navigate to the Node view and try
again.
EID-3009 No {0} was selected. Select the specified item, for example,
VLAN, port, slot, etc.
EID-3010 A bidirectional optical link could not be created. Refer to the error message text.
EID-3016 The subnet address is invalid. Refer to the error message text.
EID-3017 The subnet address already exists. Refer to the error message text.
EID-3019 The internal subnet address is incomplete. Enter the complete internal subnet address.
EID-3020 The subnet address cannot be the same for both TSC cards.
The requested action is not allowed.
A node’s internal subnet must be different
from one another as each TSC is on separate
ethernet buses, isolated by broadcast
domains.
EID-3021 An error occurred while retrieving the diagnostics:
{0}
Refer to the error message text.
EID-3022 The requested action is not allowed. The requested action is not allowed.
EID-3023 The low order cross-connect mode could not be retrieved. Refer to the error message text.
EID-3024 The {0} cross-connect mode could not be switched.
Please verify that the type and/or number of circuits
provisioned does not exceed the criterion for switching modes.
CTC cannot switch the cross-connect mode
for the specified item, as the type or the
number of circuits does not match with the
criterion for switching modes.
EID-3025 An error occurred while retrieving thresholds. There was an error retrieving the thresholds.
Table 4-1 Error Messages (continued)
Error Warning
ID Error Warning Message Description
To Next Page
Loading...
