4-24
Cisco ONS 15454 Troubleshooting Guide, R8.5
November 2009
Chapter 4 Error Messages
EID-3188 An error occurred during authentication. The password entered
is invalid.
The password you entered is invalid. Enter
the password again.
EID-3189 The sum of the {0} must be between {1} and {2}. Refer to the error message text.
EID-3214 The number of high order circuits for the line could not be
retrieved.
The number of High Orders (STS/STM) for
the line is not available.
EID-3215 An error occurred while refreshing. Used frequently in pane classes to indicate
a general error condition when trying to
refresh from the model.
EID-3216 The proxy port is invalid. Refer to the error message text.
EID-3217 The statistics could not be refreshed. CTC could not refresh statistics values.
EID-3218 The automatic node setup could not be launched. Refer to the error message text.
EID-3219 The automatic node setup information could not be refreshed. Failure trying to retrieve automatic node
setup information.
EID-3220 An error occurred while refreshing row {0}. Error refreshing the specified row.
EID-3222 The statistics could not be cleared. Refer to the error message text.
EID-3225 An error occurred while refreshing the pane. Used frequently in pane classes to indicate
a general error condition when trying to
refresh from the model.
EID-3226 The {0} termination(s) could not be deleted.
{1}
Refer to the error message text.
EID-3227 A baseline could not be recorded. Performance metrics will
remain unchanged.
CTC failed to set the baseline values while
provisioning NE. Previous values remain
unchanged.
EID-3228 The {0} termination(s) could not be created.
{1}
Refer to the error message text.
EID-3229 RIP is active on the LAN. Please disable RIP before enabling
OSPF.
Turn off the Routing Information Protocol
(RIP) on the LAN, before enabling OSPF.
EID-3230 OSPF is active on the LAN. Please disable OSPF before
enabling RIP.
Turn off the OSPF on the LAN before
enabling RIP.
EID-3231 An error occurred while setting the OPR. An error was encountered while attempting
to provision the optical power received
(OPR).
WID-3232 The port state cannot be indirectly transitioned because the port
is still providing services.
If the port state should be changed, edit it directly through port
provisioning.
Edit the port state while provisioning the
port.
EID-3233 The current loopback provisioning does not allow this state
transition.
Refer to the error message text.
EID-3234 The current synchronization provisioning does not allow this
state transition.
You cannot transition the port state to the
target date while in the current
synchronization state.
Table 4-1 Error Messages (continued)
Error Warning
ID Error Warning Message Description
To Next Page
Loading...
