106
A7. Place the subwoofers and mount the
rack cavity
Follow steps 3-4.1 starting on page 14 in the
main part of the installation guide to:
• Place the subwoofers
• Insert the rack cavity
The other cavities (steps 4.2-4.5) will be installed
later.
A8. Complete the flex tube mounting
Skip this step if you are not routing any cables between the codec and the components on the table
across the floor.
1. Lead the tubes up to the two holes in the rack
cavity to find the appropriate length. Then cut
them.
3. Unscrew and remove the nut from the
adapters.
4. Insert the tubes into the holes in the rack
cavity from below. Attach them by putting
back and tightening the nuts.
Flex tube adapters
2x
tube adapter
A6
2. Add an adapter to each tube, and tighten.
To Next Page
Loading...