107
A9. Route the antennas to the rack cavity
Skip this step if you have a non-radio product. Non-radio products, which have the letters 'NR' in their
product identifier (PID), are delivered without antennas.
A10. Mount the remaining cavities
Follow steps 4.2-4.5 starting on page 17 in the
main part of the installation guide to:
• Insert the cooling cavity
• Insert the power cavities
• Insert the display cavities
• Fasten the six cavities with screws
Skip step 5.
Cable glands
2x
Cable gland
C5
1. Thread the two antennas, which you added in
step A4, up through the small holes in the rack
cavity. The antennas are identical.
2. Attach cable glands to the antennas for strain
relief, about 0.30 m (11 in.) from the connector.
3. Fasten the antennas to the risers with velcro
to prevent them from touching the subwoofers
and cause rattling noise.
To Next Page
Loading...