110
A13. Mount components
Follow steps 6-9 starting on page 22 in the
main part of the installation guide to:
• Mount the PSU bracket
• Mount the codec and amplifier
• Attach the rating label
• Mount the Ethernet switch
Skip step 10.
Follow step 11 starting on page 28 in the main
part of the installation guide to:
• Mount the fan module
A14. Connect the antennas
Skip this step if you have a non-radio product.
Non-radio products, which have the letters 'NR' in
their product identifier (PID), are delivered without
antennas.
Guide the antennas around the codec as shown
below, and connect them to the codec. The
antennas are identical.
To Next Page
Loading...