113
A18. Mount the remaining components
and grilles
Follow steps 20-26 starting on page 60 in the
main part of the installation guide to:
• Mount the camera
• Mount the fan duct
• Mount the loudspeakers
• Mount the content screen
• Mount the right screen and deco grille
• Mount the left screen and deco grille
• Mount the speaker grille
Skip step 27.
A19. Mount and connect the components
on the table and finish up
Follow steps 28-31 starting on page 90 in the
main part of the installation guide to:
• Pull up and connect the cables between the
system and components on the table
• Mount the Ethernet switch in the table
• Place components on the table
• Finish up
Adjust the spacers so that they are 7 mm (0.3 in.) deeper than the
wallboards.
×2
10 mm
(0.4 in.)
Spacers for the main screens
7 mm
(0.3 in.)
Spacers for the content screen
Adjust the spacers so that they protrude about 10 mm (0.4 in.) outside
the wallboards.
×4
To Next Page
Loading...