23
7. Mount the codec and amplifier
7.1. Mount the codec
Codec and amplifier
1x
codec
1x
amplifier with rack ears
8x
(M5x10, Torx 25)
C2
C3
×2
The codec and amplifier are placed in the
rack cavity. The connector panels are facing
upward.
1. Remove the eight pre-mounted screws
(Hex2 mm), put the rack ears in place, and
fasten them using the same screws and screw
holes.
2. Remove the rubber feet from the codec.
3. Slide the codec into its slot. Fasten it
with four screws
(M5x10, Torx 25).
A6
2x
rack ears
To Next Page
Loading...