50
The profile is held in place by the corner and front
panels. It's not fastened by screws.
19.4. Insert a profile in the corner panel
Insert a profile (3201 #2) into the groove of the
panel, below the side trim.
Repeat the procedure on both sides.
19.3. Attach a side trim to the lower corner panel
Attach a side trim to the corner panel. The left and
right trims are not identical. Take care to put them
in the correct position.
Repeat the procedure on both sides.
1. Fit the trim fully into the groove of
the panel.
Take care to mount the trim on the
correct side. This is the trim for
the right side.
2. Fasten the trim with two screws
(M4x12, Torx 20) at the top.
Do not tighten
these screws
now.
To Next Page
Loading...