80
24.13. Assemble the deco grille
Prepare the deco grille that will be attached below
the screen. The left and right grilles are not identical.
The curved corner is toward the outside edge.
1. Remove the four screws and spacers from the
deco grille, as shown in the illustration.
You will re-use all of them when attaching the
grille support to the grille.
×4
2. Attach the grille support to the deco grille with
the same screws as you just removed.
The left and right grille supports are identical.
×4
3. Attach the vertical supports with one screw
(M6x12, Torx 30) each.
×2
These screws are also used to align the grille
to the front of the screen, so you may need to
adjust them once the grille is mounted.
These screws are also used to align the grille
to the side of the screen, so you may need to
adjust them once the grille is mounted.
To Next Page
Loading...