Cisco Small Business 200 - Page 267

Security
Defining Management Access Method
Cisco Small Business 200 Series Smart Switch Administration Guide 254
17
A caution message displays if you selected any other access profile, warning you
that, depending on the selected access profile, you might be disconnected from
the web-based configuration utility.
STEP 3 Click OK to select the active access profile or click Cancel to discontinue the
action.
STEP 4 Click Add to open the Add Access Profile page. The page allows you to configure
a new profile and one rule.
STEP 5 Enter the Access Profile Name. This name can contain up to 32 characters.
STEP 6 Enter the parameters.
• Rule Priority—Enter the rule priority. When the packet is matched to a rule,
user groups are either granted or denied access to the device. The rule
priority is essential to matching packets to rules, as packets are matched on
a first-match basis. One is the highest priority.
• Management Method—Select the management method for which the rule
is defined. The options are:
- All—Assigns all management methods to the rule.
- HTTP— Users requesting access to the device that meets the HTTP
access profile criteria, are permitted or denied.
- Secure HTTP (HTTPS)—Users requesting access to the device that
meets the HTTPS access profile criteria, are permitted or denied.
- SNMP—Users requesting access to the device that meets the SNMP
access profile criteria are permitted or denied.
• Action—Select the action attached to the rule. The options are:
- Permit—Permits access to the device if the user matches the settings in
the profile.
- Deny—Denies access to the device if the user matches the settings in
the profile.
• Applies to Interface—Select the interface attached to the rule. The options
are:
- All—Applies to all ports, VLANs, and LAGs.
- User Defined—Applies to selected interface.
• Interface—Enter the interface number if User Defined was selected.