Provisioning Basics
Upgrading, Resyncing, and Rebooting Phones
Cisco Small Business SPA300 Series, SPA500 Series, and WIP310 IP Phone Administration Guide 173
6
Parameter Description
Upgrade_Enable Enables firmware upgrade operations independently
of resync actions.
Defaults to Yes.
Upgrade_Error_Retry_Delay The upgrade retry interval (in seconds) applied in
case of upgrade failure. The device has a firmware
upgrade error timer that activates after a failed
firmware upgrade attempt. The timer is initialized with
the value in this parameter. The next firmware upgrade
attempt occurs when this timer counts down to zero.
The default is 3600 seconds.
Downgrade_Rev_Limit Enforces a lower limit on the acceptable version
number during a firmware upgrade or downgrade.
The device does not complete a firmware upgrade
operation unless the firmware version is greater than
or equal to this parameter.
The default is (empty).
Upgrade_Rule This parameter is a firmware upgrade script with the
same syntax as Profile_Rule. Defines upgrade
conditions and associated firmware URLs.
The default is (empty).
Log_Upgrade_Request_Msg Syslog message issued at the start of a firmware
upgrade attempt.
The default is
$PN $MAC -- Requesting upgrade $SCHEME://
$SERVIP:$PORT$PATH
Log_Upgrade_Success_Msg Syslog message issued after a firmware upgrade
attempt completes successfully.
The default is
$PN $MAC -- Successful upgrade $SCHEME://
$SERVIP:$PORT$PATH -- $ERR
Log_Upgrade_Failure_Msg Syslog message issued after a failed firmware
upgrade attempt.
The default is
$PN $MAC -- Upgrade failed: $ERR.
License Keys This field is empty.
To Next Page
Loading...
