14 Silicon Switch Processor (SSP) Installation and Configuration
Additional Show Commands
Additional Show Commands
Use the show commands for determining the successful installation and operation of the SSP.
The show sse summary command displays the following summary of the processor statistics:
Router# show sse sum
SSE utilization statistics
Program words Rewrite bytes Internal nodes Depth Rebuilds
Overhead 500 5 4
IP 6607 133 6550 15 1
IPX 0 0 0 0 2
SRB 0 0 0 0 2
CLNP 0 0 0 0 44082
IP access lists 0 0 0
Total used 7107 138 6554
Total free 58429 262006
Total available 65536 262144
Internals
15001487 internal nodes allocated, 14994933 freed
SSE manager process enabled, microcode enabled and running, 0 hangs
Router#
The show ip cache command displays the following:
Router# show ip cache
IP routing cache version 0, 5827 entries, 819880 bytes
Minimum invalidation interval 2 seconds, maximum interval 5 seconds,
quiet interval 3 seconds, threshold 0 requests
Invalidation rate 0 in last second, 0 in last 3 seconds
Prefix/Length Age Interface MAC Header
6.0.0.0/8 2:02:35 Hssi1/0 0F000800
13.0.0.0/8 1:23:57 Fddi0/0 00000C0BA9DA00000C0DDF9CAAAA0300
00000800
15.0.0.0/8 0:00:44 Fddi0/0 00000C0BA9DA00000C0DDF9CAAAA0300
00000800
16.0.0.0/8 0:20:15 Fddi0/0 00000C03510300000C0DDF9CAAAA0300
00000800
17.0.0.0/8 0:19:14 Fddi0/0 00000C0BA9DA00000C0DDF9CAAAA0300
00000800
The show ip interface brief command displays the interfaces that are enabled.
To display statistics, including the controller type, MAC addresses, and microcode versions, enter
the show controllers cbus command, as follows:
Router# show cont cbus
Switch Processor 5, hardware version 12.0, microcode version 10.8 Altera 4
Microcode loaded from system
2048 Kbytes of main memory, 128 Kbytes cache memory
4 256 byte buffers, 4 1024 byte buffers, 438 4496 byte buffers
Restarts: 0 line down, 0 hung output, 0 controller error
FIP 0, hardware version 2.4, microcode version 10.2
Microcode loaded from system
Interface 0 - Fddi 0/0, address 0000.0c04.b038 (bia 0000.0c04.b038)
62 buffer RX queue threshold, 47 buffer TX queue limit, buffer size 4496
ift 0006, rql 32, tq 0000 01C0, tql 47
To Next Page
Loading...
Need help?
General
