Starting Installation and Cabling of the Front Row Table
© 2015 Cisco Systems, Inc. All rights reserved.
Page 57
8
Assemble the power outlets to the outlet covers prior to installation to the table legs. a. Take the 6x
Power/Ethernet connectivity modules (part number varies by country) and assemble them to the 4x
Power/Ethernet connectivity cover 700-47772-xx using the #4-40 nuts included with the power/Ethernet
module. b. Use the blanking plates 700-45421-xx for the two outside legs as shown and attach using 8x
04-40 nuts 49-0326-xx. Tip: Hold the cover flat and install the nuts from below using a nut driver to facilitate
installation.
2x Power/Ethernet
Modules
700-47772-xx
8x #4-40 nuts
1x Power/Ethernet
Modules
700-47772-xx
8x #4-40 nuts
700-45421-xx
2x Inside legs 2x outside legs
To Next Page
Loading...
