Installing and Cabling the Displays
© 2015 Cisco Systems, Inc. All rights reserved.
Page 85
10
Install the 2x 800-41842-xx vertical bezel extrusions between the displays. a. Insert the extrusion
center rib between the left and center displays, and insert the hook into the slot in the center pillar. b.
Insert 4x M4x12 screws 69-2797-xx into the lower part of the extrusions (2x each per extrusion) and tighten
the screws with a #2 Phillips driver. Do NOT use a power driver for this procedure and do not overtighten. c.
Push the left and right displays from the sides towards the center against the extrusions to take up any gaps.
Leave the fim on the front of the displays.
2x 800-41842-xx
800-41842-xx
Slot
Hook
2x 69-2797-x x
To Next Page
Loading...
