Cisco WAP100 Series Administration Guide

SNMP
Groups
Cisco WAP571/E Administration Guide 150
10
• authNoPriv
• authPriv
Access to Management Information Bases (MIBs) for each group is controlled by
associating a MIB view to a group for read or write access, separately.
By default, the AP has two groups:
• RO—A read-only group using authentication and data encryption. Users in
this group use an MD5 key/password for authentication and a DES key/
password for encryption. Both the MD5 and DES key/passwords must be
defined. By default, users of this group have read access to the default all
MIB view.
• RW—A read/write group using authentication and data encryption. Users in
this group use an MD5 key/password for authentication and a DES key/
password for encryption. Both the MD5 and DES key/passwords must be
defined. By default, users of this group have read and write access to the
default all MIB view.
NOTE The default groups RO and RW cannot be deleted.
NOTE The AP supports a maximum of eight groups.
To add and configure an SNMP group:
STEP 1 Select SNMP > Groups in the navigation pane.
STEP 2 Click Add to create a new row in the SNMPv3 Groups table.
STEP 3 Check the box for the new group and click Edit.
STEP 4 Configure the parameters:
• Group Name—A name that identifies the group. The default group names
are RO and RW.
Group names can contain up to 32 alphanumeric characters.
• Security Level—Sets the security level for the group, which can be one of
these options:
- noAuthentication-noPrivacy—No authentication and no data
encryption (no security).

Cisco WAP100 Series Specifications

General

Brand	Cisco
Model	WAP100 Series
Category	Wireless Access Point
Language	English