56
Using the chronograph
The chronograph on this watch can measure up to 23 hours 59 minutes 59.95 seconds
in 1/20 second increments.
1
Change the mode to [
CHR
] and push the crown in to
position
0
.
The chronograph hands move to indicate 0.00 second.
2
Start measurement.
• See the next page for the method of measurement.
• Pulling out the crown will stop and reset the chronograph.
3
Change the mode to [
TME
] and push the crown in to
position
0
to finish the procedure.
The second hand returns to indicate the seconds.
To Next Page
Loading...
